Bubblesorba designer acoustic panels are used to absorb noise in reverberant spaces such as restaurants, offices, showrooms, studios, homes, etc.

These acoustic panels have unique shapes with unsurpassed choices in shapes and colours, so that they can be visually pleasing and unique. These panels can visually lift up the customers profile and tailor a noise solution for their room.

Our products are durable, They last a long time and are manufactured with materials that enables them to always keep the same shape.

Bubblesorba designer acoustic panels are an artistic decoration as well as being acoustic. The basic shapes lead to millions of combination of patterns and colours. Do you love soft shapes or the strictly graphical? We have them. The products contribute to creating unique and creative spaces so that people can be comfortable both aurally and visually.

Bubblesorba designer acoustic panels can be used over and over again. They can be moved and make new combinations for generations.

Acoustic Performance

The Bubblesorba acoustic panels possess very good sound absorbing ability. These panels contribute to reducing distubing noise and reduce the echo. The panels also absorb 85% of the incident sound – Class A.

The product has the highest possible measured sound absorption coefficient at the middle and high frequencies, i.e. between 500-4000Hz. This is the important speech frequency.

Installation

Bubblesorba acoustic panels are simply adhered to walls/ceilings using Gluesorba contact spray can adhesive. Gluesorba contact adhesive is a quick spray-on application which comes in ready to use spray cans.

The backing surface must be clean, flat, level, dry, solid and free from dust, oil, grease and other similar residue which may affect adhesion. We recommend that the contact adhesive is applied at room temperature of approximately 21° and in well ventilated conditions.

The spray adhesive should be held 150mm to 300mm away from the surface and at a constant 90° angle. To avoid overspray onto the edges of the panel or other surfaces, it may be necessary to mask any vulnerable areas.

The panel and wall/ceiling surfaces should be fully coated and then allowed to dry for 3 – 5 minutes before bonding the surfaces together.

The panels should be placed accurately into position as the adhesive creates an immediate bond upon contact. Once the panel is in place it should be pressed gently but firmly to ensure overall contact.

Bubblesorba sound absorption panels installation

We recommend a test adhesion is carried out to full satisfaction, before proceeding with the full installation. Glue coverage should be 100% on each of the surfaces.